![]() I connected the printer to Octoprint, turned it on and used the Firmware Updater plugin to flash the firmware. Your Ender 3 will not have any firmware installed at this stage, so turning on the printer will result in a blank screen on the display. Voila! You now have a bootloader installed. You will see the progress bar at the bottom. It should take around a 1 minute and 20 seconds to flash the bootloader. Using the Load Flash in top right corner, select the bootloader file optiboot_flash_atmega1284p_UART0_115200_16000000L_BIGBOOT.hex.Ensure the USB ISP controller is detected, icons need to be in color. ![]() Click the menu and configure as follows. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |